Home   » Transistor data » this page

BC558 Transistor Data

Key transistor data for the BC558 PNP switching and amplifier transistor including key electrical parameters, pinout, package type and many other key transistor details.



Key details and performance parameters for the BC558 transistor.


BC558 transistor parameters & data
 
Parameters Details
Transistor type PNP silicon switching and amplifier transistor
Package type TO92 (plastic)
VCBO max (V) -30
VCEO max (V) -30
VEBOmax (V) -5
VCEsat (V) -300mV @ I -10 mA
IC max (mA) -100
TJ Max °C 150
PTOT mW 500
fT min (MHz) 150
COB 6
hfe 110 - 800
IC for hfe -2mA
Similar / equivalents

    Outline:



    Pinout:

Notes:   This is a widely used low power high voltage switching, amplifier and general purpose PNP transistor.

Noise figure is typically 2dB at 1 kHz but the maximum value is 10 dB.

There are different designations for different current gain levels A= 110 - 220; B=200 - ~450, C = 420 - 800.



Explanation of transistor parameters


Parameter Explanation
VCBO Max Maximum collector-base voltage with emitter open circuit .
VCEO Max Maximum collector-emitter voltage with base open circuit.
VEBO Max Maximum emitter-base voltage with collector open circuit.
VCEsat (included where applicable) The voltage drop across the collector-emitter when the transistor is fully saturated (acting as a closed switch).
IC Max Maximum collector current.

Parameter Explanation
TJ Maximum junction temperature.
PTOT Max Maximum device dissipation normally in free air at 25°C unless other conditions indicated.
fT Min Minimum cutoff frequency at which the current gain in a common emitter circuit falls to unity.
COB Max Maximum collector capacitane, normally measured with emitter open circuit.
hFE DC current gain for HFE at IC. [Note hfe is the small signal gain and although this may be slightly different, the transistor current gain will vary considerably from ne transistor to the next of the same type.]
PTOT Max Maximum device dissipation normally in free air at 25°C unless other conditions indicated.

These are the main transistor parameers that have been included in our list. There are others, but these help quantify the main elements of the performance of the transistor.

 



Please note, that the data given is the best estimate we can give within a tabulated summary of this nature. Parameters also vary between manufacturers. Electronics Notes cannot accept any responsibility for errors, inaccuracies, etc, although we do endevaour to ensure the data is as accurate as possible.

Ian Poole   Written by Ian Poole .
  Experienced electronics engineer and author.




    Return to Component Data menu . . .